RYL Forums

RYL Forums (https://www.recoveryourlife.com/forum/index.php)
-   First Aid Advice (https://www.recoveryourlife.com/forum/forumdisplay.php?f=57)
-   -   Why won't it scab? (https://www.recoveryourlife.com/forum/showthread.php?t=19664)

DropDead- 06-10-2007 12:20 AM

Why won't it scab?
 
Well yesterday at like 1-half 1 in the morning i cut myself,very badly,worse i've ever done it. And well,i have no clue about measurements or anything,i can't find a ruler O.o,but the cuts i did are about (-----) That wide.
Anyways,i covered it and everything and left it. This morning,they seem to have gotten wider (or it may just be my eyesight). And i'm slightly worried because the cuts are just all white inside and there's no sign of scabbing whatsoever. And i know it's only been like 23 hours,but my wounds tend to heal very quickly,within hours.
I've not told anybody yet,because i kept a promise with my physcologist that i wasn't going to cut/overdose by the time i see her next.And well i can't tell anybody else =[

So yeh,does anybody know why it won't scab?

Thank you
Yaz xx

ourleanne 06-10-2007 12:31 AM

Hi,

I'm not sure but it sounds like you have cut really deep and needed steri-strips or stitches. The white inside sounds like fat, like little balls almost? It takes a lot longer to scab over when it's deep and apparently more chance of infection so they tell me at the hospital. I think you may need to get some more advice, I'm new here but I think you can contact the first aid team where it says contact in the top right hand corner of your screen. Take good care, hope you're ok.

Leanne

Aidee 06-10-2007 12:39 AM

What you are describing sounds like the normal healing process to me.

Wounds heal in 2 ways, from the inside out, and from the outside in. The better way for them to heal is inside out. When a scab forms on a wound it means that it is healing from the outside in, and that the edges were able to join together.

If you covered the cut with band aid, gauze or antibiotic cream it generally won't scab up (scabs can only form if the wound dries) as a scab is basically your bodies version of a band aid.

It's also possible that the cut is too deep to form a scab, as scabs won't form over deep wounds. You should speak with your doctor about seeing if it is deep enough to need stitches.

DropDead- 06-10-2007 12:59 AM

Ohh right. Noo i put a plaster on it for about 15 minutes but then took it off because it bled through,so just put my jacket on and forgot about it.
Ohh,but isn't there a limit to how long after the cuts been made until you can get stitches?
I may walk into the walk in doctor centre thing tomorrow,but it doesn't look bas enough to need stitches,then again i'm not a doctor or anything.

Thanks guys.
Yaz xx

completely_gone 06-10-2007 11:18 AM

i do believe that if the healing process has started which it probably has, that stitches will not likly be a possibility, but it's always good to check your wounds out to ensure that they are in fact healing properly without infection. the wound that you described sounds like the wounds that I have on a regular basis and like above said, it does take time for a scab to appear because for me it does heal from the inside up. please take care of yourself.

Jayda 06-10-2007 10:59 PM

It is too late to get stitches, there's a danger if it's stitched too late. It sounds like it's healing already anyhow. The best bet is to keep it clean and bandaged, and keep an eye out for infection.

True, most superficial cuts heal within days, but if they're deeper, then it will take some time. Instead of days for healing time, you're looking more around weeks for it to fully heal.

DropDead- 06-10-2007 11:16 PM

Now i feel silly =X

Oh well,better safe that sorry eh?

Thanks alot guyss :] xxx
Yaz xx

Jayda 06-10-2007 11:25 PM

Don't feel silly. The only silly question is the one not asked. Hope you're healing well now. And it's always better to be safe than sorry.


All times are GMT +1. The time now is 06:07 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.